Page 146 - RHAU-MKT RYCO Product Technical Manual 2018-12-14 v1-9
P. 146

 HOSE
THERMOPLASTIC
 TP8N
ISOLATOR
R8 NON CONDUCTIVE HOSE
                                 RECOMMENDED FOR:
Hydraulic oil lines where electrical non-conductivity is required (for use in applications where there is potential for contact with high voltage sources). Suitable for use with mineral, vegetable and most ester based hydraulic fluids. Heat and hydrolysis stabilised for use with water based hydraulic fluids up to +70°C (+158°F). Smooth inner tube for high flow rate; and smooth, easily cleaned cover.
The high strength, non-metallic reinforcement gives these hoses excellent corrosion and fatigue resistance, and low elongation of ±2% at maximum dynamic working pressure.
PERFORMANCE:
Meets or Exceeds the Performance Requirements of: AS 3791 100R8, EN 855 TYPE R8, ISO 3949, SAE 100R8.
TUBE:
White, oil resistant seamless thermoplastic (Polyester).
REINFORCEMENT:
One or two braids of aramid fibre.
COVER:
Orange, oil and abrasion resistant thermoplastic (Polyurethane). Cover is non-perforated.
FEATURES:
Meets non-conductivity requirements of SAE 100R7,
AS 3791 100R7, EN 855 Type 7 (maximum leakage does not exceed 50 μA when subjected to 75 kV/305 mm or 250 kV/m for 5 minutes). Incorrect storage and use, particularly that leading to oil or moisture entering the reinforcement, may adversely affect electrical properties.
TEMPERATURE RANGE:
From -40°C to +100°C (-40°F to +212°F). Air & Water +70 ˚C (+158 ˚F).
For water, emulsions etc. see page 58.
WORKING PRESSURE:
Maximum working pressures are based on 4:1 safety factor (maximum working pressure to minimum burst pressure).
COUPLINGS:
NON-SKIVE ONE-PIECE CRIMP
TP000 Series (sizes -04 to -16) pages 304 to 316. Assembly Instructions pages 478.
               TP8N – ISOLATOR NON-CONDUCTIVE HOSE
                       PART NO
HOSE SIZE
NOMINAL HOSE ID
NOMINAL HOSE OD
MAXIMUM WORKING PRESSURE
MINIMUM BURST PRESSURE
MINIMUM BEND RADIUS
AVERAGE WEIGHT
COUPLING SERIES ONE PIECE
                          Hose
DN
Dash
mm
inch
mm
inch
bar
psi
bar
psi
mm
inch
kg/m
lb/ft
NON-SKIVE
                                 TP84N
6
-04
6,5
1/4
11,5
0.45
350
5000
1400
20000
50
2.0
0,09
0.06
TP000
                 TP86N
10
-06
9,7
3/8
15,5
0.61
280
4000
1120
16000
60
2.4
0,14
0.09
TP000
                 TP88N
12
-08
13,0
1/2
19,9
0.78
245
3500
980
14000
80
3.1
0,20
0.13
TP000
                                  Refer to the latest RYCO Crimp Charts for crimp diameter and mark lengths.
       144 RYCO QUALITY
   144   145   146   147   148