Page 147 - RHAU-MKT RYCO Product Technical Manual 2018-12-14 v1-9
P. 147

     THERMOPLASTIC
 TP8T
SPIDERLINE R8 TWIN HOSE
                            RECOMMENDED FOR:
RYCO TP8T SPIDERLINE TWIN Hose consists of two TP8 Series Hoses of the same size, permanently joined together in a
flat compact form that can be easily reeled onto payout and return reels on forklifts and cranes. It is also used on dispensing equipment and other applications requiring two hoses.
High pressure hydraulic oil lines; pilot lines; greasing and lubrication lines; and some pneumatic and water lines. Suitable for use with mineral, vegetable and most ester based hydraulic fluids. Suitable for use with some gases, fluids and chemicals. Cover is perforated (pin-pricked) for use with air and gases.
RYCO SPIDERLINE hose is lighter weight, has a more compact outside diameter and is less than half the minimum bend radius of wire braided rubber hose. Smooth inner tube for high flow rate; and smooth, easily cleaned cover.
The synthetic and aramid fibre reinforcement gives SPIDERLINE hose excellent corrosion and fatigue resistance plus low elongation at maximum dynamic working pressure.
PERFORMANCE:
Meets or Exceeds the Performance Requirements of: AS 3791 100R8, EN 855 TYPE R8, ISO 3949, SAE 100R8.
TUBE:
White, oil resistant seamless thermoplastic (Polyester).
REINFORCEMENT:
One or two braids of aramid fibre.
COVER:
Black, oil and abrasion resistant thermoplastic (Polyurethane). Cover is perforated (pin-pricked).
TEMPERATURE RANGE:
From -40°C to +100°C (-40°F to +212°F). Air & Water +70 ˚C (+158 ˚F).
For water, emulsions etc. see page 58.
WORKING PRESSURE:
Maximum working pressures are based on 4:1 safety factor (maximum working pressure to minimum burst pressure).
COUPLINGS:
NON-SKIVE ONE-PIECE CRIMP
TP000 Series (sizes -04 to -16) pages 304 to 316. Assembly Instructions pages 478.
                  TP8T – SPIDERLINE TWIN HOSE
                       PART NO
HOSE SIZE
NOMINAL HOSE ID
NOMINAL HOSE OD
MAXIMUM WORKING PRESSURE
MINIMUM BURST PRESSURE
MINIMUM BEND RADIUS
AVERAGE WEIGHT
COUPLING SERIES ONE PIECE
                          Hose
DN
Dash
mm
inch
mm
inch
bar
psi
bar
psi
mm
inch
kg/m
lb/ft
NON-SKIVE
                                 TP84T
6
-04
6,5
1/4
11,5
0.45
350
5000
1400
20000
50
2.0
0,17
0.11
TP000
                 TP86T
10
-06
9,7
3/8
15,5
0.61
280
4000
1120
16000
60
2.4
0,27
0.18
TP000
                 TP88T
12
-08
13,0
1/2
19,9
0.78
245
3500
980
14000
80
3.1
0,40
0.27
TP000
                                  Refer to the latest RYCO Crimp Charts for crimp diameter and mark lengths.
       CONNECTING PARTNERSHIPS 145
TECHNICAL ADAPTORS COUPLINGS HOSE INTRODUCTION
   145   146   147   148   149