Page 165 - 2019 PRODUCT TECHNICAL MANUAL - HYDRAULICS V4-8

HOSE PROTECTION – RHYS PACKAGING SLEEVE
RHYS PACKAGING SLEEVE
RECOMMENDED FOR:
Packaging and protection of hose assemblies, in transit and in storage. RYCO RHYS Packaging Sleeve is installed over the finished hose assembly. The ends may be heat sealed, or folded over and stapled, or taped closed.
CONSTRUCTION:
Heavy gauge low density polyethylene clear plastic tubing; printed at intervals with “RYCO” logo, and incorporating an area for the hose assembly Part Number
to be written.
PACKAGING SLEEVE
PART NO
NOMINAL ID
NOMINAL WALL THICKNESS
NOMINAL INSIDE FLAT DIMENSION
NOMINAL WEIGHT
RHYS-75
48
1.9
0,15
0.006
75
3.0
0,021
0.014
RHYS-125
A mm
79
ASSEMBLY INSTRUCTIONS:
1. Select correct size of RYCO RHYS Packaging Sleeve. It must be large enough to allow for the maximum outside profile of the hose couplings.
2. Two sizes are available:
3. RHYS-75 suits most hoses up to -16 (1”) hose bore. 4. RHYS-125 suits most hoses from -16 to -32 (1” to 2”)
hose.
5. If required, write the hose assembly Part Number onto
the Packaging Sleeve using a ball point pen.
6. Slide the hose assembly into the RHYS Packaging
Sleeve.
7. Trim Packaging Sleeve to length, and seal ends.
STANDARD COIL LENGTHS:
350 metres (1,150 feet).
RHYS HOSE ASSEMBLY PACKAGING SLEEVE SPECIFICATIONS
A inch B mm B inch C mm C inch kg/m lb/ft
3.1 0,15 0.006 125 5.0 0,035 0.023
CONNECTING PARTNERSHIPS 163
TECHNICAL ADAPTORS COUPLINGS HOSE INTRODUCTION