Page 467 - 2019 RYCO Product Technical Manual V1-8
P. 467

 HOSE ASSEMBLIES OF SPECIFIC LENGTHS
All RYCO hose assemblies are manufactured seat to seat length unless otherwise specified by customer. The length of a Hose Assembly can be measured in three ways:
1. SEAT TO SEAT LENGTH. (RYCO STANDARD, UNLESS OTHERWISE SPECIFIED).
Length is measured from tip of seat to tip of seat.
2. OVERALL LENGTH. (OA)
Length is measured from tip of nut to tip of nut.
3. CUT HOSE LENGTH. (CL)
This is the length that the hose is cut to before couplings are attached. The length of the couplings is extra.
NOTE: For male fittings and flanged fittings, seat and overall length measurement points are the same.
ORIENTATION OF FITTINGS.
Proper positioning of elbow end fittings on a hose is governed by the offset angle, or the amount of angular offset between connecting parts in the installation. If this angle of orientation is not correct in the construction of a hose assembly the performance and life of the assembly will be greatly reduced.
Orientation is determined by the number of degrees between the fitting furthest from the viewer and the fitting nearest to the viewer, measured in a clockwise direction.
ORIENTATION TOLERANCES:
± 3° on lengths up to 600 mm (24”). ± 5° on lengths over 600 mm (24”).
HOW TO ORDER HOSE ASSEMBLIES
TECHNICAL ADAPTORS COUPLINGS HOSE INTRODUCTION
CONNECTING PARTNERSHIPS 465


















































































   465   466   467   468   469