Page 479 - 2019 RYCO Product Technical Manual V1-8
P. 479

 ASSEMBLY INSTRUCTIONS FOR:
RYCO FIELD ATTACHABLE COUPLINGS WITH MATCHED SIZES OF RYCO SKIVE HOSE.
USE ON LARGER SIZES OF RYCO T1D, T2D and RQP2 HOSE, SEE NOTE 1 & 2 on page 476).
STEP ONE
• Cut hose to length required using a cut-off saw.
• Ensure hose is cut squarely.
• Clean hose bore.
STEP THREE
• Lightly lubricate exposed wire reinforcement.
STEP FIVE
• Lightly lubricate insert and inside of hose.
• Note: Do not use lubricant for hose to be used with volatile gases.
STEP TWO
FIELD ATTACHABLE SKIVE HOSE ASSEMBLY
TECHNICAL ADAPTORS COUPLINGS HOSE INTRODUCTION
Mark Length
• Mark Skive Length (refer to Hose specification pages).
• Cut rubber cover around and down to wire reinforcement then
slit lengthwise.
• Raise flap and pull off with pliers.
STEP FOUR
• Screw anti-clockwise until hose bottoms in ferrule. • Ease back between 1/2 and 3/4 of a turn.
STEP SIX
• Screw insert clockwise right into ferrule using a continuous motion. • Do not allow hose to turn during operation.
CONNECTING PARTNERSHIPS 477










































































   477   478   479   480   481