Page 73 - 2019 PRODUCT TECHNICAL MANUAL - HYDRAULICS V4-8

ISOBARIC BRAID
T6000D EXTRA ABRASION RESISTANT FRAS
COMPACT ISOBARIC HOSE 420 BAR / 6100 PSI
RECOMMENDED FOR:
Extremely high pressure hydraulic oil lines. Constant pressure (Isobaric) 420 bar / 6100 psi in all sizes. Small bend radius and compact dimensions are advantages in installations.
PERFORMANCE:
Meets or Exceeds the Performance Requirements of: ISO 18752-BC.
TUBE:
Black, oil resistant synthetic rubber.
REINFORCEMENT:
Two braids of high tensile steel wire.
COVER:
DIEHARDTM Black, oil and extra abrasion resistant synthetic rubber. Flame Resistant, Anti-Static (FRAS) & MSHA compliant. Highly visible layline branding for easy and permanent identification. No skiving required with T2000 Series Crimp Couplings.
FEATURES:
Constant pressure 420 bar / 6100 psi in all sizes for easy system design and hose selection. Small bend radius and compact dimensions are advantages in installations.
FRAS - FLAME RESISTANCE AND ANTI-STATIC:
DIEHARDTM complies with Flame Resistant and Electrical Resistance (Anti-Static) requirements of Australian Standard AS 2660 and Methods of Test AS 1180.10B and 13A. Meets Flame Resistant Designation “U.S. MSHA” of the US Department of Labor, Mine Safety and Health Administration.
TEMPERATURE RANGE:
-40°C to +100°C (-40°F to +212°F).
For water, emulsions etc. see page 58.
WORKING PRESSURE:
Maximum working pressures are based on 4:1 safety factor (maximum working pressure to minimum burst pressure).
THIRD PARTY APPROVALS:
ABS, DNV-GL, LR, MED, USCG, GOST-R, BV, RINA and KR.
COUPLINGS:
NON-SKIVE ONE-PIECE CRIMP
T2000 Series (sizes -04 to -06) pages 189 to 234. Assembly Instructions pages 480.
T6000D – DIEHARD COMPACT ISOBARIC HOSE
PART NO
HOSE SIZE
NOMINAL HOSE ID
NOMINAL HOSE OD
MAXIMUM WORKING PRESSURE
MINIMUM BURST PRESSURE
MINIMUM BEND RADIUS
AVERAGE WEIGHT
COUPLING SERIES
ONE PIECE
Hose DN Dash mm inch mm inch bar psi bar psi mm inch kg/m lb/ft NON-SKIVE T6005D 8 -05 8,2 5/16 15,6 0.61 420 6100 1680 24400 55 2.2 0,35 0.24 T2000
Refer to the latest RYCO Crimp Charts for crimp diameter and mark lengths.
T6004D
6
-04
6,6
1/4
13,2
0.52
420
6100
1680
24400
50
2.0
0,28
0.19
T2000
T6006D
10
-06
9,8
3/8
17,6
0.69
420
6100
1680
24400
65
2.6
0,47
0.32
T2000
HIGHER TECHCNOONLNOEGCYTEINQUGAPLASRGTNREARTSEHRIPPSERFORMANCE 71
TECHNICAL ADAPTORS COUPLINGS HOSE INTRODUCTION