Page 85 - 2019 PRODUCT TECHNICAL MANUAL - HYDRAULICS V4-8

RECOMMENDED FOR:
Ultra flexiblility and small bend radius provides easy installation in compact environments.
Extremely high pressure hydraulic oil lines.
Constant pressure (Isobaric) 420 bar / 6100 psi in all sizes.
PERFORMANCE:
Meets or Exceeds the Performance Requirements of: ISO 18752-CC, SAE 100R15.
TUBE:
Black, oil resistant synthetic rubber.
REINFORCEMENT:
Four alternating layers of spiralled high tensile steel wire.
COVER:
SLIDER Black, oil and extremely abrasion resistant synthetic rubber sheathed with a layer of extremely abrasion
resistant polyethylene. Flame Resistant, MSHA compliant. Highly visible layline branding for easy and permanent identification. No skiving required with T7000 Series Crimp Couplings.
FEATURES:
Ultra flexibility combined with a small bend radius reduces effort during assembly and installations. Tested to 1 million impulse cycles at up to 1/2 SAE 100R15 Minimum Bend Radius. Constant pressure 420 bar / 6100 psi in all sizes for easy system design and hose selection.
MSHA - FLAME RESISTANCE:
SLIDER complies with Flame Resistant requirements
of Australian Standard AS 2660 and Methods of Test
AS 1180.10B. Meets Flame Resistant Designation
“U.S. MSHA” of the US Department of Labor, Mine Safety and Health Administration.
TEMPERATURE RANGE:
-40°C to +121°C (-40°F to +250°F).
WORKING PRESSURE:
Maximum working pressures are based on 4:1 safety factor (maximum working pressure to minimum burst pressure).
COUPLINGS:
NON-SKIVE ONE-PIECE CRIMP
T7000 Series (sizes -12 to -16) pages 274 to 304. Assembly Instructions pages 480.
ISOBARIC SPIRAL
C6000S
ULTRA FLEXIBLE
EXTREMELY ABRASION RESISTANT ISOBARIC SPIRAL HOSE
420 BAR / 6100 PSI
MILLION CYCLE
C6000S – SLIDER
ULTRA FLEXIBLE ISOBARIC SPIRAL HOSE
NOMINAL HOSE ID
NOMINAL HOSE OD
MAXIMUM WORKING PRESSURE
MINIMUM BURST PRESSURE
MINIMUM BEND RADIUS
AVERAGE WEIGHT
COUPLING SERIES
PART NO
HOSE SIZE
ONE PIECE
Hose DN Dash mm inch mm inch bar psi bar psi mm inch kg/m lb/ft NON-SKIVE C6016S 25 -16 25,4 1 35,8 1.41 4.20 6100 1680 24400 165 6.5 1,75 1.17 T7000
Refer to the latest RYCO Crimp Charts for crimp diameter and mark lengths.
C6012S
19
-12
19,1
3/4
28,5
1.12
420
6100
1680
24400
115
4.5
1,15
0.77
T7000
HIGHER TECHCNOONLNOEGCYTEINQUGAPLASRGTNREARTSEHRIPPSERFORMANCE 83
TECHNICAL ADAPTORS COUPLINGS HOSE INTRODUCTION