Field Attachable Skive Hose Assembly - RYCO Hydraulics

Field Attachable Skive Hose Assembly

ASSEMBLY INSTRUCTIONS FOR:

RYCO FIELD ATTACHABLE COUPLINGS WITH MATCHED SIZES OF RYCO SKIVE HOSE.
USE ON LARGER SIZES OF RYCO T240A and T240D HOSE, SEE NOTE 1 & 2 ON PAGE 496).

STEP ONE:

002_step_one

Cut hose to length required using a cut-off saw.
Ensure hose is cut squarely.
Clean hose bore.

STEP TWO:

003_step_two

Mark Skive Length. (refer to Hose specification pages).
Cut rubber cover around and down to wire reinforcement.
Slit lengthwise.
Raise flap and pull off with pliers.

STEP THREE:

003_step_three

Lightly Lubricate exposed wire reinforcement.

STEP FOUR:

002_step_three

Screw anti-clockwise until hose bottoms in ferrule.
Ease back between 1/2 and 3/4 of a turn.

STEP FIVE:

002_step_four

Liberally oil insert and inside of hose.

STEP SIX:

002_step_five

Screw insert clockwise right into ferrule using a continuous motion.
Do not allow hose to turn during operation.