H6032D and H6032S

» Technical » Hose Assembly Guides » H6032D and H6032S

Optional for H6012, 16, 20, 24 D and S Hoses

ASSEMBLY INSTRUCTIONS FOR:
6900N SERIES BITELOK INTERLOK TWO-PIECE INTERNAL AND EXTERNAL SKIVE COUPLINGS.
USE ONLY MATCHED HOSES.

Note: Extra special care must be exercised in the preparation, assembly and crimping of these couplings due to the very high pressures and end loads encountered.

STEP ONE:

H6032D and H6032S step one
Cut hose to length required using a cut-off saw.
Ensure hose is cut squarely.
Clean hose bore.

STEP TWO:

H6032D and H6032S step two
Use RYCO Internal and External Skive Tool to skive the cover and the tube.
Check that External Skive length is correct.
Check that Internal Skive length is correct. (Refer to “RYCO Crimp Chart”).
Clean hose bore, and skived area of cover

STEP THREE:

H6032D and H6032S step three
Slide ferrule onto hose

STEP FOUR:

H6032D and H6032S step four
Push hose tail of fitting into the hose bore (lightly lubricate the hose bore only if necessary as excess lubrication may reduce hose assembly impulse life).
The raised collar on the hose tail must abut the end of the hose.
Ensure that the locking collar of the ferrule is aligned with, and will lock into, the collar on the hose tail.
Check that the ferrule completely covers the skived part of the hose cover

STEP FIVE:

H6032D and H6032S step five
Place assembled end into jaws of crimp machine.
Operate machine to crimp ferrule to predetermined diameter.
(Refer to “RYCO Crimp Chart”).
Open crimp machine and remove assembly.
Ensure that the locking collar of the ferrule is locked into the collar on the hose tail

STEP SIX:

H6032D and H6032S step six
Check crimp diameter with caliper or micrometer.
Crimp diameter should be measured halfway along the ferrule.
Measure between the ridges, and make sure that the caliper fingers do not touch the ridges.
Check that the ferrule still completely covers the skived part of the cover to ensure coupling has not moved during crimping.
RYCO Crimp Chart detailing Internal and External Skive Length and Crimp Diameter is available from RYCO Hydraulics.
WordPress Image Lightbox Plugin